Skip to content

Install RustSC on Windows

Paste one command into PowerShell and your Windows host is installed and connected.

Install and connect

Closing the RustSC window leaves it running in the notification area. Your servers keep running either way.

  1. In the portal, open Hosts, then Add host, and choose the Windows tab.
  2. Choose Copy install command. The command already holds your connection code.
  3. On the host that will run your servers, open PowerShell from the Start menu. Paste the command and press Enter.
  4. Choose Yes when Windows asks for permission. RustSC installs and connects by itself.
  5. In the portal, wait for the host to show Connected, then choose Add server.

If something goes wrong

  • PowerShell says the code was already used or has expired: copy the command again from Add host. It holds a new code.
  • PowerShell says it stopped: it says why and what to do. Run the same command again; it picks up where it left off.
  • RustSC is already installed: open it and paste the code under Connect to your workspace, then choose Connect.
  • The host does not show Connected: open RustSC on the host. It says whether it is connected.
  • No command is offered on the page: Windows installation is not available from this service yet.

Analytics settings

Analytics are off.

Help improve RustSC with page counts and performance measurements. Privacy details