Skip to main content

How to check rail and road routes on a Rust map candidate

Check whether the rail or road route you need actually runs between its intended stops. Turning a feature on only makes it eligible to generate.

Name the journey before you choose the seed

For example, if you want a train-based event, pick a starting stop and a destination near a useful landmark. Check that AboveGroundRails is enabled if the route needs surface rail. Facepunch's guide lists a 4,250 map-size requirement for procedural above-ground rails. A smaller road-only candidate can be fine for a convoy event.

Trace it, then travel it

Open the map and trace the path between the stops. Load the test world and try the actual journey. If the path exists on paper but does not reach the place you need, compare another seed or revise the event route. Keep the candidate only when someone can make the intended trip in game.

Check the return trip if players will be expected to make it. Record any switch or transfer they need so the event instructions match the route you tested.

Sources

Analytics settings

Analytics are off.

Help improve RustSC with page counts and performance measurements. Privacy details